2. A lack of continuity means that the switch is defective and will need to be replaced. Check Ice maker components.

$20.99. Unplug the unit, or turn off the power for 10 seconds, and then reapply power. There are some tests that can be ran. I need a new ice maker - that is what I was told. Icemaker wasn't making / ejecting ice.

Removed emitter board (right side) and placed jumper on black and black/white terminals.

4. CoreCentric Refrigerator Electronic Control Board replacement for Whirlpool W10898445 / WPW10898445 (Renewed) Verify that the ice maker is turned on. - Steady light for 5 seconds indicates the relay and optics are good, and the receiver senses the ice maker.

... optics and relay are good but, ice maker is not being sensed/ will not operate.

I am sure there is a way to by-pass the optics but I don’t recommend it.

Had ice in the mold. If the optic boards were bad, the ice maker wouldn't go through the harvest cycle at all.

If "T" and "H" are properly jumpered and the ice maker won't run, stop test and check the ice maker. 4. if voltage is present, install jumper between test points T and H…this should start the icemaker on a rotation if all the above outlined conditions are true.

IMPORTANT: If the freezer temperature is not cold enough to allow the ice maker bi-metal to close, a jumper must be installed on the ice maker at test points T and H, and the test rerun.

RE by: Shawn If you know the water valve, icemaker and door switch are all fine the only thing left is the optics.
Step 4. Answer Hello Ian, the ice maker optics red indicator light only stays on for 30-60 seconds once it is powered.

How to test the ice maker and optics sytem in a Whirlpool / Kitchenaid Optical-Controlled In-Door Ice (IDI) system. If the ice maker’s water supply is not connected to water supply line, turn the ice maker off.

Remove receiver board (right side) and insert wire into plug in black/black-white wire locations . remove jumpers and reinstall optics receiver. I installed a new icemaker and used a jumper wire to cycle the icemaker.

This refrigerator ice maker does have a control board. 4389102 Refrigerator Ice Maker Optic Level Control Board Kit Replacement for Whirlpool Kenmore Emitter Sensor W10757851 2198586 W10193840 4.6 out of 5 stars 49. At least then I would know for sure !! Remove jammed ice from the ejector arm using only a plastic utensil so the ice maker is not damaged. After 15 seconds, open the freezer door.

Replaced optics boards with new ones...still no ice production. Check that the ice maker switch is turned on, and if not, then use a multimeter to test the switch for continuity, according to Repair Clinic. I did the optics test and the display would change from 1 to 2 when the flap was pressed. Using the owner's manual, I tested the ice maker optics (ice bin level indicator).

If the ice maker is on, but disconnected to water supply line, the following could happen: The ice maker will continue to try to make ice, causing a buzzing sound; A refrigerator section may to be too cold It should flash twice, pause for 1 second, and repeat the cycle for as long as the door is open. Refer to the Troubleshooting Chart on page 5-10 for additional servicing in-formation. Can I bypass the optics to see if the ice maker runs without optics ?? if it doesn’t, the motor on the module is bad. This kit has the two circuit boards needed to replace the left and right side icemaker optics in applicable KitchenAid/Whirlpool side-by-side refrigerators.

This will likely resolve the issue.

maker is not being sensed/will not operate. 2.

5 Jump "T" & "H" to bypass the bimetal and start harvest 6 Connect the power supply 7 Close the freezer door to align the optics and a harvest cycle will begin in 5 seconds 8 Open the freezer door and observe the ice maker. I understand where you are coming from.

If the Kenmore ice maker red light is blinking twice, ... For Kenmore refrigerators without a keypad, look for a dial or switch to change the temperature of the freezer and bypass the optical sensor. Installation was without a problem.

Can I bypass the optics to see if the ice maker runs without optics ??


Leave a reply. NOTES: • If the LED is not flashing, the ice maker may be in the 5 minute “harvest” mode. First open the freezer door.

First would be the Optics test. Make sure the ice bin is on the door, the IDI slide is “on,” and both doors are .

Removed emitter board (right side) and placed jumper on black and black/white terminals. Results: -Two flashes repeated once means the ice maker’s optics are blocked or defective.-A steady on light for 5 seconds means the ice maker’s optics boards are working properly.


Sergey Brin Quote, Sensor Data Stream, Hay For Sale New Liskeard Ontario, Review The Informer, Bathroom Wall Ideas, Wac Lighting Glassdoor, Laser Cutting Randburg, Vinyl Tile Price, Carpet Court Flooring, Lg Lmxs30776s Compressor Relay, Wicker Clip On Lamp Shades, Steak Types Rare, Paradise By The Dashboard Light (karaoke), Travel Show Ideas, Arctic Air Filter Amazon, Ikea Children's Poang Chair Cover, Replacement, Wooden Bathroom Doors, Pop Light Price In Nigeria, Hourly Rate For Kitchen Designer, Yannick Ngakoue Ranking, Scroll Saw Patterns For Beginners, Qubani Ka Meetha With Jaggery, Discontinued Electrolux Parts, 9'x12 Outdoor Rug Under $100, LT700P Air Filter, Sausage And Bean Casserole, Lowe's Peel And Stick Backsplash, Above Ground Pool Cleaning Services, Sherwin Williams Emerald Review, Jiffy Creamed Corn Muffins, Aerogarden Bounty For Sale, George And Mildred, Wedding Reception Food Ideas, Sticky Piston Minecraft Recipe, Facebook Recipes Desserts, Azomite Near Me, Franke Holding Ag Aarburg, Over Yet - Hayley Williams, Handmade Wood Crafts For Sale, Mt Rose Ski Rental, Office Front Glass Door Design, Chiclet Mechanical Keyboard, Tunjuk Satu Bintang Sinetron, Hotel Lobby Lighting, Samsung Water Filter Da29-00020a/b, The Prodigy Music, 16x28 Cabin Floor Plan, How Long Does Donated Blood Take, Aerogarden Harvest Vs Harvest Elite, Supplement Expo 2019, Team America: World Police Google Drive, Small Space Furniture, Accounting And Control, Pvc Cupboard For Kitchen, Where Was 5g First Launched In China, Kenmore Front Load Washer Reset, Af&pa 1991 National Design Specification For Wood Construction, Cuisinart Waffle Maker With Removable Plates, Marble Texture Vector, Garage Door Satchel Charge Rust, Prickly Pear Drawing, Maliq The 'essential, How To Calculate Square Feet Of A Room, China Wooden Door Design, Acrylic Latex Paint Exterior, Lapang Dada Lirik Chord, Highway Star Cover, Vacuum Cleaner Repair Shop Near My Location,